---
title: "Switch connector"
question: "Why not wire a radio to both of its antennas?"
url: "https://nearfieldnotes.com/videos/switch-connector/"
site: "Near Field Notes"
video: "https://nearfieldnotes.com/media/switch-connector/full.mp4"
duration: "2:06"
date: "2026-11-12"
note: "https://nearfieldnotes.com/notes/switch-connector/"
---

# Switch connector (video)

Why not wire a radio to both of its antennas?

2:06, with sound. [Read Note 32](https://nearfieldnotes.com/notes/switch-connector/) for the full answer, with figures, conditions and sources.

## Transcript

One radio, two antennas. Why not just wire both?

Because the power splits. 46% reaches the antenna you want.

This connector has a switch inside, and gets about 96% there.

Let's see how it works, 2 other ways to do it, and which cables fit.

Here's the board. A radio, a PCB antenna, and a connector for an external one.

The easy layout is a tee. Both stay wired to the radio.

I simulated it at 2.45 GHz, with the cable plugged in.

The radio sees two loads in parallel, so 14% bounces straight back.

The rest splits. 46% to the cable, and 39% to the antenna you didn't want.

Unplug the cable, and the empty branch is a stub.

This one is 6 mm long. At 2.4 GHz, 83% still reaches the antenna.

At 5.5, almost nothing does. There the stub and its pad add up to a quarter wavelength, and it acts like a short.

A switch connector fixes both. It's 2.3 mm square, and it sits right in the trace.

Inside, a spring on the radio side presses up against a fixed contact on the antenna side.

With nothing plugged in, the signal passes straight through, and loses under 4%.

Push the plug in. Its center pin shoves the spring down, off the contact.

Now the radio feeds the pin and the cable, and the PCB antenna is cut off.

At most 1% leaks across the gap.

There are 2 other ways to pick an antenna.

First, a 0 Ω resistor. Solder it toward the antenna, or toward the connector.

It's cheap and it loses almost nothing. But changing antennas takes a soldering iron.

Second, an RF switch chip. Firmware picks the antenna, even while it runs.

It needs power and a control pin, and a typical one loses 10%.

The switch connector needs no firmware and no solder. Plugging in the cable flips it.

The catch is wear. Its plug is only rated to go in 30 times.

And that plug is not a U.FL.

A U.FL plug has a socket in the middle. This switch needs a pin to push the spring.

So you buy the cable made for your switch. Two makers sell one for antennas.

Others only take test probes, because these parts were made for factory testing.

And it has a direction. The spring side goes to the radio.

Mount it backward, and the plug connects your cable to the PCB antenna.

Wire both, and less than half arrives. Switch, and nearly all of it does.

---

Source: https://nearfieldnotes.com/videos/switch-connector/
