---
title: "Peltier generator"
question: "What does a Peltier module make when it’s run as a generator?"
url: "https://nearfieldnotes.com/videos/peltier-generator/"
site: "Near Field Notes"
video: "https://nearfieldnotes.com/media/peltier-generator/full.mp4"
duration: "2:39"
date: "2026-11-15"
note: "https://nearfieldnotes.com/notes/peltier-generator/"
---

# Peltier generator (video)

What does a Peltier module make when it’s run as a generator?

2:39, with sound. [Read Note 40](https://nearfieldnotes.com/notes/peltier-generator/) for the full answer, with figures, conditions and sources.

## Transcript

This Peltier module is on a wrist. From the body to the room, there's 15 °C.

The module gets half a degree. That makes 32 mV.

Here's why, the chip that can start from that, and where this effect has run for 49 years.

Last video, this module was a cooler. Current went in, and the carriers took heat with them.

Now heat one side. The carriers there move faster and drift to the cold side.

That pile-up is a voltage: about 0.4 mV per degree, for each pair of legs.

127 pairs in series: 49 mV per degree.

So it's a voltage source behind about 2 Ω.

It was a DC motor last time. Turn a motor's shaft, and it's a generator.

I simulated it, and checked the model against two published bench tests of this same part.

With the hot side at 80 °C, the most it's rated for, and 55 °C across: 2.75 V open, and 0.75 W into the best load.

But 37 W of heat went through it. That's 2%.

The limit for any heat engine at those temperatures is 16%.

It's the cooler's two taxes again. The legs have resistance, and they leak heat straight through.

And drawing current makes it pass more heat. Open circuit, 28 W. Shorted, 46.

It's a generator fighting its shaft.

So on a weak heat source, loading it cools the hot side. With 40 W of heat, 63 °C across it falls to 51.

Back to the wrist. Heat flow is a circuit too. Temperature is the voltage.

The body, the module and the air are three resistors in series.

The module is the small one. It gets 3% of the drop.

The most power comes when the module takes half. Legs 30 times as long would give 9 times the power.

Citizen's watch did that with 2,268 pairs of hair-thin legs. It got 0.8 V per degree, saw 1.2 °C, and made 12 µW.

A quartz watch needs 1.

Our module makes 32 mV. An ordinary boost converter needs about 0.6 V to wake up.

The LTC3108 starts from 20 mV. Its switch is on with no gate voltage, so a 1:100 transformer can start it ringing.

On this module it starts at about half a degree. At 2 °C it delivers 0.4 mW.

A few percent is as good as it gets. So these win where nothing else can run.

More than 35,000 burn gas on pipelines, at about 3%, for 20 years each.

And Voyager launched with 470 W of them in 1977. It still has over 200.

A Peltier run backward is a voltage source: 49 mV per degree, behind 2 Ω.

What limits it is how much of the temperature difference it gets.

On a wrist: 15 °C, half a degree, 32 mV.

---

Source: https://nearfieldnotes.com/videos/peltier-generator/
