---
title: "Power inductors, part 2"
question: "Is a toroid the quietest inductor?"
url: "https://nearfieldnotes.com/videos/inductor-types-2/"
site: "Near Field Notes"
video: "https://nearfieldnotes.com/media/inductor-types-2/full.mp4"
duration: "1:56"
date: "2026-11-11"
note: "https://nearfieldnotes.com/notes/inductor-types-2/"
---

# Power inductors, part 2 (video)

Is a toroid the quietest inductor?

1:56, with sound. [Read Note 36](https://nearfieldnotes.com/notes/inductor-types-2/) for the full answer, with figures, conditions and sources.

## Transcript

Same 4.7 µH.

The toroid puts 80× less noise on the trace next to it.

Here are the inductors I skipped last time.

A toroid is a ring core, with the wire wound through the middle.

Every turn's field stays inside the ring.

What leaks out is the wire's one trip around the ring.

So it leaks like one turn, not the whole winding.

Bring the wire back across the top, and the leak drops over 10×.

Send it back around the outside, and the noise doubles.

The catch: they're wound one turn at a time.

And this small one has 3× the resistance of a molded part.

Gapped ferrite stores its energy in a tiny air gap.

The gap's field bulges out into the nearest wire.

Wound tight on the core, that wire loses 11× more than on a core with no gap.

Keep it 2 to 3 gaps away.

Where the gap sits matters for noise too.

Hidden in the center post, the trace next door sees almost nothing.

Gap the outer wall as well, and it's 24× noisier.

The gap sets the inductance, so it can be held to 3%.

But ferrite holds its inductance, then falls off a cliff.

A coupled inductor puts two windings on one core.

In this converter, both windings see the same voltage.

With two separate parts, each one ripples 2 A.

Couple them, and it's about 1 A.

That's what parts with twice the inductance would give.

Server power stages couple every phase, so they all answer a load step together.

A thin-film chip plates a copper coil inside metal powder.

Same box as last time's multilayer chip, and it holds its inductance to over 10× the current.

But it leaks more than twice the noise.

A ferrite bead isn't really an inductor.

Up high, it acts like a resistor and turns noise into heat.

And DC current kills it. 1 A takes this one from 105 Ω to 15.

At its full rating, just 4 Ω are left.

A PCB spiral is just copper, so there's nothing to saturate.

But 4.7 µH takes 35 mm of board.

And a solid plane under it wipes out 93%.

Cut the plane away, and it comes back.

Here's every one on the same trace.

Quietest of all: a pot core with its gap hidden inside.

---

Source: https://nearfieldnotes.com/videos/inductor-types-2/
